The Right Click Tools Dashboards require access to specific portions of your enterprise environment that are controlled outside of Right Click Tools. For example, the Hardware and Firmware Audit Dashboard reads from the ConfigMgr database to populate its information. Enabling this requires that information about the ConfigMgr database be entered into Right Click Tools, and also requires permissions on the databases themselves.
Right Click Tools with Recast Management Server
If you're running Right Click Tools with Recast Management Server, enter ConfigMgr and MBAM Database information on the Settings page the Recast Management Server interface.
To enter SQL and MBAM database information in Recast Management Server:
1. In your Recast Management Server interface, navigate to the Settings page.
2. In the ConfigMgrServer section, enter:
- SQL Server: the FQDN of the Server that hosts the SQL database for ConfigMgr
- SQL Database: the name of the database hosted on the above server (usually CM_Three letter site code)
3. If you have MBAM in your environment, enter the following details in the MBAM section:
- MBAM Administration URI: The Administration URI for your MBAM server, the address is usually correct after the FQDN is entered unless it was changed at the time of installation
- SQL Server: The FQDN of the server that hosts the SQL Database for MBAM
- MBAM Recovery and Hardware Database name (default name is entered)
- MBAM Compliance Status Database name (default name is entered)
NOTE: Once these settings are in place, make sure that you have permissions on those specific databases.
Right Click Tools Standalone
If you are running Right Click Tools in Standalone mode, you'll need to enter SQL and MBAM database information in the Configure Recast RCT application.
To enter SQL and MBAM database information in Configure Recast RCT:
1. Open the Configure Recast RCT application.
2. On the SQL Configuration tab, enter:
- SQL Server: the FQDN of the Server that hosts the SQL database for ConfigMgr
- SQL Database: the name of the database hosted on the above server (usually CM_Three letter site code)
3. If you have MBAM in your environment, enter:
- MBAM Administration URI: The Administration URI for your MBAM server, the address is usually correct after the FQDN is entered unless it was changed at the time of installation
- SQL Server: The FQDN of the server that hosts the SQL Database for MBAM
- MBAM Recovery and Hardware Database name (default name is entered)
- MBAM Compliance Status Database name (default name is entered)
4. Click Save.